Sains Malaysiana 33(1): 99-107 (2004)                                                                                         Sains Hayat /

Life Science

 

Influence of Inlet Air Temperature and Feed Flow Rate on the Physical Properties of Spray-dried Mengkudu (Morinda citrifolia) Extract

 

 

Mohamad Yusof Maskat & Yeow Lee Ling

Food Science Program

Schaal of Chemical Sciences and Food Technology

Faculty of Science and Technology

Universiti Kebangsaan Malaysia

43600 UKM Bangi, Selangor D.E.,,Malaysia

 

 

ABSTRACT

 

Due to the increase in consumer interest, mengkudu (Morinda citrifolia) extract is being produced in several forms including dry powder. One of the methods that can be used to produce dry powder is spray drying. This study was done to determine the physical properties of powdered mengkudu extract produced by spray drying from different sections of the spray-dryer. Mengkudu extract at 50% (v/v) dilution was spray-dried using two levels of feed flow rate (350 mL/hr and 475 mL/hr) and inlet air temperature (170oC and 190oC).  Spray dried mengkudu extract from the cyclone and colletion sections of the spray dryer was collected and analyzed for amount produced, moisture content and colour. No significant interaction between feed flow rate and inlet air temperature used was observed for all parameters measured. Inlet temperature used did not show any significant effect on amount of production.  However, increasing the inlet air temperature from 170oC to 190oC did produce  lower moisture content for samples from the cyclone  but no significant difference for samples from the collection bottle, while lowering the degree of redness of samples from the collection bottle, while lowering the degree of brightness for samples from both cyclone and collection sections of the spray-dryer. Feed flow rate used did not produce any significant effect on all parameters measured.

 

 

ABSTRAK

 

Peningkatan minat pengguna terhadap ekstrak mengkudu telah menyebabkan ianya dihasilkan dalam pelbagai bentuk termasuk serbuk. Antara kaedah yang boleh digunakan untuk penghasilan serbuk mengkudu adalah kaedah pengeringan semburan. Kajian ini telah dijalankan untuk menentukan ciri fizikal serbuk mengkudu yang dihasilkan melalui pengeringan semburan dari bahagian pengering semburan yang berbeza. Ekstrak mengkudu pada pencairan 50% (v/v) telah dilakukan pengeringan semburan menggunakan dua tahap kadar suapan (350 mL/j dan 475 mL/j) dan suhu udara masuk (170oC dan 190oC). Ekstrak mengkudu yang telah dikeringkan dari bahagian botol pengumpul dan siklon dianalisa untuk jumlah penghasilan, kandungan lembapan dan parameter warna. Tiada interaksi yang signifikan di antara suhu udara masuk dan kadar suapan telah didapati untuk semua parameter yang diukur. Suhu udara masuk tidak menunjukkan kesan signifikan terhadap jumlah penghasilan. Tetapi, peningkatan suhu udara masuk dari 170oC kepada 190oC menghasilkan kandungan lembapan yang lebih rendah bagi sampel dari bahagian siklon tetapi tidak untuk bahagian botol pengumpul. Peningkatan suhu udara masuk dari 170oC kepada 190oC juga meningkatkan darjah kemerahan sampel dari botol pengumpul serta menurunkan darjah kecerahan bagi sampel dari kedua-dua botol pengumpul dan siklon. Kadar suapan yang digunakan didapati tidak menghasilkan kesan yang signifikan terhadap semua parameter yang diukur.

  

 

RUJUKAN/REFERENCES

 

AOAC. 1990.  Official Methods of Analysis.  Association of Official Analytical Chemists, Arlington, VA.

Azizah, A.H., Jamilah, B. & H.B. 2002.  Nutritional Quality of Spray Dried Protein Hydrolysate from Black Tilapia (Oreochromis mossambicus). Food Chemistry 78: 69-74.

Cepeda, B., Vlaran, M.L. & Aranguiz, N. 1998. Functional Properties ot Faba Hean (Vicia faba) Protein Flour Dried by Spray Drying and Freeze Drying. Journal of Food Engineering 36: 303-310.

Coumans, W.J., Kerkhof, P.J. & Bruin, S. 1994. Theoretical and Practical Aspects of Aroma Retention in Spray Drying and Freeze Drying. Drying Technology 12: 99 - 149.

Etzel, M.R., Suen, S.Y., Halverson, S.L. & Budijono, S. 1996. Enzyme Inactivation in a Droplet Forming a Bubble during Drying. Journal of Food Engineering 27: 17-34.

Jumah, R.Y., Tashtoush, B., Shaker, R.R. & Zraiy, A.F. 2000. Manufacturing Parameters and Quality Characteristics of Spray Dried Jameed. Drying Technol­ogy 18: 967 - 968.

Kievet, R. & Kerkhof, J.A.M. 1994. Automatic Moisture Control of Process Dryers in the Agriculture and Food Industries. In Rudolph, V. (ed.). Drying '94.­Proceeding of the 9th. International Drying Symposium. Volume A. Australia.

Linares, E., Larre, C. & Popineau, Y. 2001. Freeze or Spray Dried Gluten Hydrolysates. I. Biochemical and Emulsifying Properties as a Function of Drying Process. Journal of Food Engineering 48: 127-135.

Moniz, H. 1994. Noni (Morinda citrifolia) As a Pharmaceutical Product. U.S. Patent 5,288,491.

Sang, S., Kan, H., Liu, G., Zhu, N., Wang, M., Jhoo, J., Zheng, Q., Dong, Z., Ghai, G., Roen, R.T. & Ho, C.T. 2001. Citrifolinin A, a New Unusual Iridoid with Inhibition of Activator Protein-I (AP-I) from Leaves of Noni (Morinda citrifolia L.). Tetrahedron Letters 42: 1823 -1825.

SAS. 1988. User's Guide. Release 6.03. SAS Institute, Cary, NC.

Singh, Y.N., Ikahihifo, T., Panuve, M. & Slatter, C. 1984. Folk Medicine in Tonga - A Study on The Use of Herbal Medicines for Obstetric and Gynaecologiacal Conditions and Disorders. Journal of Ethnoparmacology 12: 305-329.

Singh, Y.N. 1986. Taditional medicine in Fiji: Some Herbal Folk Cures Used by Fiji Indians. Journal of Ethnopharmacology 15: 57-88.

Stevenson, R.J. & Chen, D. 1996. A Study of Volatile Trapping in Spray Dried Whey Protein Concentrate by Crushing and/or Vacuuming, and Detection by Solid­Phase Microextraction/Gas Chromatography/Mass Spectrometry. Food Research International 29 (5-6): 495-504.

 

 
sebelumnya